FASTENERS

The right fasteners, installed correctly will make the project. Understanding which fasteners are best for which application is critical. Be sure to match the correct screw or fastener option with the appropriate roof or wall system. For more information check with your FabralCore representative.

Fabral now offers the #10 WoodTite High Low fastener.

The #10  fastener is the #1 fastener in the industry and is a proven performer.  Not only is it the preferred fastener in the Post Frame Industry but it complements your Fabral projects perfectly. In addition, the #10 fastener:

  • Penetrates metal more quickly with the TYPE-17 POINT
  • Allows for FASTER DRILL TIMES with the Hi Low thread configuration
  • Provides HIGHER pull-out values
  • DE-BURRS metal shards due to the ASTOR THREAD design
  • Features a ¼” hex head

Complete Offering:

#10WoodTite High Low #12 x 3/4 Stitch #10-16 Uitimate WoodTite #10-12 Wafer Head

#10 HL

 12-.75 WoodFast  10-16 Ultimate WoodTite 10-12 Wafer Head 
  • Use with Dimensional Lumber
  • Available in 1″, 1½”, 2″, 2½” and 3″
  • 1/4″ hex head, EPDM/Metal washer
  • Oxyseal Long-Life Coating
  • Plain and Painted available
  • Use for trim attachment for Horizon S
  • 1/4″ hex head, EPDM/metal washer
  • Painted available
  • Use with ALL panels
  • Available in 1″, 1½” 2″, 2½” and 3″
  • 5/16″ case zinc hex head
  • Hex head & washer all one piece
  • Plain available
  • Use with Horizon S panel
  • Check with engineering department for spacing with OSB or 1/2″ plywood
  • Available in 1″, 1½”, 2″, 2½” and self drillers
  • Available with square drive head
  • Plain available
#10 HLx WoodTite Fastener Brochure      
       
#14-10 WoodTite #10-14 410 Stainless Steel #9-16 Series Stainless Steel #10-1 Pancake Head
14-10 WoodTite  410 Stainless Steel  300 Series Stainless Steel  10-1 Pancake Head 
  • Use to fasten metal to plywood or OSB
  • Use for trim attachment
  • Available in 1″, 1½” and 2″
  • 5/16″ hex head, EPDM/metal washer
  • Oxyseal Long-Life Coating
  • Plain and painted available
  • Use with 26 gauge or thinner to avoid pre-drilling
  • Available in 1″, 1½” and 2″
  • 1/4″ hex head, EPDM/metal washer
  • Use with steel panels installed on treated lumber
  • Use with aluminum
  • Plain and  painted available
  • Use for high corrosive environments
  • Use with ALUMINUM panels
  • Available in 1″, 1½” and 2″
  • 1/4″ hex head, EPDM/metal washer
  • Use with treated lumber
  • Plain and painted available 
  • Use with 1½” SSR and concealed fastener panels
  • Check with engineering department for spacing with OSB or 1/2″ plywood